![]() Specific example: I tried to use a 256Gb SD card in a GoPro Connect2 camera, which only fully supports 64Gb cards. In this case the USB drive can be reformatted using a device that does fully support it, and then Rufus will work through that device. You may not be aware of this without checking the device's specs. Lastly, type “assign” to give this USB key a drive letter and “exit” to exit DiskPart.Īnother possibility is the device used to connect the USB drive to the PC doesn't fully support the drive - it can use it, but not format it properly.This should take a few minutes, and DiskPart will display a progress percentage. Format the key by inputting “format fs=fat32".Choose this partition with “select partition 1", and then mark it as active by typing “active”.Create a new partition by entering “create partition primary”.Type “clean” for the utility to clean the disk, which DiskPart will confirm.Type “select disk n" (whatever is your USB disk number in place of "n"). ![]() Note the USB key’s disk number – you can pick it out by looking at the disk capacity. ![]() If your USB key is plugged into your PC, it should be listed here, along with other drives. Type in “list disk” to show a list of all disk drives.It will take a second until it loads and when ready it will read “DISKPART>”. At the prompt, enter “DISKPART” to launch Microsoft’s disk management utility.Go in Start > write “cmd” > right-click the Windows Command Prompt and choose to run it as an Administrator.And, frankly, there are lots of reasons the Installation Guide should be updated (it's something like four years old) but there's no reason to expect that to happen anytime soon.I was able to fix the damaged USB by doing the following: This is the first I've heard of drives being bricked.Īnyway, be aware, Mint's developers don't participate on the Forum and, so, are unlikely to see your post. Things settled down a few years ago, but now the problem seems to have returned, though usually it's merely that the drive won't boot. Each burn app worked for some users but not others and there wasn't much of a pattern. ![]() That said, there might be an incompatibility between Etcher and some flash drive controllers, etc. And, bear in mind, it does happen occasionally that a flash drive is dead-on-arrival (has happened to me). That's a mild sort of breaking, isn't it? I take it Rufus wasn't able to burn to the PNY drive?įWIW, I just burned the Cinn21 ISO to flash drive with the current version of Etcher. I was later able to burn the ISO to the old SanDisk USB stick on the first try using Rufus and can see it on there. Something is going wrong with Balenta Etcher. One - the SanDisk drive - was clearly working properly immediately before trying to burn the new Mint ISO using Etcher. The same problem occurred on both drives, so it's clearly not a manufacturer problem. iso on it, but I wanted a newer version for a fresh install. The second was an older SanDisk drive with an old Mint. The first was a fresh out of the box PNY drive.Using Windows" AFTER the drives were made useless. The explanation from Balena is not satisfactory, and I would suggest updating the Linux Mint installation guide to recommend another source.īefore saying more, I will acknowledge that I was about to get my USB drives working again using their guide, "How to Recover a USB Drive or SD Card burn.html.īalena Etcher keeps going through the process to burn the ISO, and then I get a pop-up saying my drive is 'write protected' and I end up with a blank USB. The Linux Mint installation guide suggests using Balena Etcher to create the bootable USB stick. There's some mention of this in various places, but I think it's worth pointing out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |